Silicone around the monofin HELP!!!!

[Hollydell]

Hello MerNetowrk <3

So ive been trying to figure this out for a while and please bare with me.

If the silicone has a hard time curing when touching the monofin, how is it able to cure to the powermesh thats still touching the monfin?

35669

If the grey line represents the monofin,

the red line respesents the powermesh,

the green lines respesent the glue holding the powermesh to the monofin,

and they yellow repesents the silicone,

would the yellow line, not leak though the power mesh (indicated by the vertical lines) and then not cure properly?

If this question doesn't make sense I'll try to ask it a different way but I'm really trying here :P

PS ignore the dots at the top of the picture.

[Mermaid Kate Silverfin]

It really depends what your monofin is made of. If you have a plastic or fibreglass blade, it will cure against it fine (e.g. Hydra, Competitor), but if it is rubber it will not. Also, if the foot pockets are rubber, it won't cure against that either.

[Hollydell]

I have the competitor, so when you say it will cure against it, will it stick to the monofin or is the power mesh still needed?


Sent from my iPhone using Tapatalk

[Mermaid Wesley]

It will not stick to it.


Sent from my iPhone using Tapatalk

[Mermaid Kate Silverfin]

Yep, as Wesley said, it won't stick to the monofin. You still need to adhere powermesh to it.

[Hollydell]

thanks so much for the help!!!

[xaccer2]

Подс (http://audiobookkeeper.ru/book/1425)

[xaccer2]

135 (http://cottagenet.ru/plan/213)

[xaccer2]

позв (http://eyesvision.ru)