Problems with the fin :(

[tina8109]

Hello) could you tell me as you leete fin to monolete?silicon not glued to monolete, the bubbles are formed

[Meilyn]

If possible, make little drainage holes to let the water pass through.

Mind sharing who was your tail maker?

If it's a recent purchase, try to have your tail maker correct the problem?

[tina8109]

The tail is made by me. There are drainage holes23624

[tina8109]

23625

[Kishiko]

I'm sorry I don't think I understand what you mean? If it's made by you, can't you glue it to the monofin?

[tina8109]

I can is not glued :( (

[MerEmma]

You'd need to open the fin back up again to glue it down, I believe? Is that what you're getting at?

[PearlieMae]

I think the silicone is not sticking to the monofin.

Your drainage holes need to be bigger and at the bottom part of where the problem is, not at the top. I drew where you should put in new slits to drain the water.

SilPoxy Glue might adhere your fin to your monofin if you can get it where you live.

---

Я думаю, что силикон не придерживаясь моноласты.


Ваши дренажные отверстия должны быть больше и в нижней части, где проблема, не на самом верху. Я обратил где вы должны положить в новых щелей, чтобы слить воду.


SilPoxy Клей может придерживаться свой ​​плавник на ваш моноласты если вы можете получить его там, где вы живете. Я постараюсь и перевести это на русский с Google, я надеюсь, что это имеет смысл!

23626

[tina8109]

you are gluing thus silicone or Silpoxy? If I make the drainage holes at the bottomon on the fin is not interesting holes are formed

[PearlieMae]

It doesnt have to be big holes, slits will let the water out and prevent ballooning.