Quote Originally Posted by Mermaid Jaffa View Post
Hey, I noticed the cuts are not equal on both sides.

On a large piece of paper, trace one side of the fluke/monofin that you think looks the best, then mark with dotted line where the middle is on the plastic sheet. Then using the paper, line it up against the dotted line and trace around for the other side of the fluke/monofin.
Hi! I know the cuts aren’t equal, because I wasn’t done cutting them yet. First I took over the fin I made. That I cut, and later I will trace them with paper and cut them again. (It’s just to make sure it actually fits)