Hi all!
Almost at the end of my tail build... I've got both my silicone fluke halves and a mesh pocket around the monofin however I don't want a big air/water pocket in the fluke. I've been recommended various glues to stick the silicone down but nothing will stick to my monofin as its polypropylene (the hydra).
Has anyone found a glue that will stick to the hydra? it doesn't have to stick to silicone too as I can stick the mesh to the monofin and then the silicone to the mesh.
Drilling holes in the monofin is my last resort. I've been told it can cause the fin to split so would like to avoid it but I'm guessing again this is a bigger problem with fibreglass fins and the plastic might be ok?
Any advice much appreciated!
Bookmarks