I'm kind of limited in fluke specifics because I'm playing around with a tiny sheet of lexan, but this is the shape I think I'll end up going with instead. The one I wanted to make was bigger than the sheet I have would allow. But I think it should make for a decent fin? (Ignore the red marks on my feet... I've been sitting on the floor for a while, haha)
The only thing I'm not sure about is if I could use some of the leftover scraps lined up against each other to help reinforce the foot area or not. I wouldn't have enough for a single piece to cover it, but I would if I combined the two sections that get cut away from the top half of the fin. It'd just need some trimming depending on how much area it would cover.. Do you guys think that would work or would the fact that it'd be two pieces side by side on top of the main piece be something that would cause issues down the road since it wouldn't be a solid second piece on top of the first?
Reply With Quote
Bookmarks